HP FlexFabric 5700 series Configuration Manual page 60

Step
2. Enter Ethernet interface view.
3. Enable byte-count or
packet-based WFQ
queuing.
4. Assign a queue to the SP
group.
5. Assign a queue to the WFQ
queue scheduling group,
and configure a scheduling
weight for the queue.
6. (Optional.) Configure the
minimum guaranteed
bandwidth for a queue.
Configuration example
1. Network requirements
Configure SP+WFQ queuing on interface Ten-GigabitEthernet 1/0/1, and use packet-based
WFQ.
Assign queues 4 through 7 to the SP group.
Assign queues 0 and 1 to WFQ group 1, with the weights being 1 and 2, respectively. Assign
queues 2 and 3 to WFQ group 2, with the weights being 1 and 3, respectively.
Configure the minimum guaranteed bandwidth for each of the four queues as 128 Mbps.
2. Configuration procedure
# Enter system view.
<Sysname> system-view
# Configure SP+WFQ queuing on Ten-GigabitEthernet 1/0/1.
[Sysname] interface ten-gigabitEthernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] qos wfq weight
[Sysname-Ten-GigabitEthernet1/0/1] qos wfq 4 group sp
[Sysname-Ten-GigabitEthernet1/0/1] qos wfq 5 group sp
[Sysname-Ten-GigabitEthernet1/0/1] qos wfq 6 group sp
[Sysname-Ten-GigabitEthernet1/0/1] qos wfq 7 group sp
[Sysname-Ten-GigabitEthernet1/0/1] qos wfq 0 group 1 weight 1
[Sysname-Ten-GigabitEthernet1/0/1] qos bandwidth queue 4 min 128000
[Sysname-Ten-GigabitEthernet1/0/1] qos wfq 1 group 1 weight 2
[Sysname-Ten-GigabitEthernet1/0/1] qos bandwidth queue 5 min 128000
[Sysname-Ten-GigabitEthernet1/0/1] qos wfq 2 group 2 weight 1
[Sysname-Ten-GigabitEthernet1/0/1] qos bandwidth queue 6 min 128000
[Sysname-Ten-GigabitEthernet1/0/1] qos wfq 3 group 2 weight 3
[Sysname-Ten-GigabitEthernet1/0/1] qos bandwidth queue 7 min 128000
Command
interface interface-type
interface-number
qos wfq [ byte-count | weight ]
qos wfq queue-id group sp
qos wfq queue-id group { 1 |
2 } { weight | byte-count }
schedule-value
qos bandwidth queue queue-id
min bandwidth-value
54
Remarks
N/A
The default queuing algorithm on an
interface is WRR.
By default, all the queues of a
WFQ-enabled port are in WFQ group
1.
Select weight or byte-count according to
the type (byte-count or packet-based) of
WFQ you have enabled.
If you have enabled WFQ on the port,
all the queues are in WFQ group 1 by
default and the default scheduling
weight is 1 for each queue.
The default setting is 64 kbps for each
queue in a WFQ group.