Lsp Path Discovery - Cisco ASR 9000 Serie Configuration Manuals

LSP Path Discovery

Command or Action
lsp-monitor
RP/0/RSP0/CPU0:router(config-ipsla-mplslm)#
Step 4
schedule monitor monitor-id
Example:
RP/0/RSP0/CPU0:router(config-ipsla-mplslm)#
schedule monitor 2
RP/0/RSP0/CPU0:router(config-ipsla-mplslm-sched)#
Step 5 frequency seconds
Example:
RP/0/RSP0/CPU0:router(config-ipsla-mplslm-sched)#
frequency 600
Step 6 schedule period seconds
Example:
RP/0/RSP0/CPU0:router(config-ipsla-mplslm-sched)#
schedule period 300
Step 7
start-time hh:mm:ss [day | month day]
Example:
RP/0/RSP0/CPU0:router(config-ipsla-mplslm-sched)#
start-time 11:45:00 July 4
Step 8
commit
LSP Path Discovery
Perform this task to configure the LSP Path Discovery (LPD) and its required parameters, including echo
interval, path, and scan.
Cisco ASR 9000 Series Aggregation Services Router System Monitoring Configuration Guide, Release 4.2.x
276
Implementing IP Service Level Agreements
Purpose
Enters IP SLA MPLS LSP monitor schedule configuration
mode to schedule the MPLS LSP monitor instance.
(Optional) Specifies the frequency at which the schedule
period is run. The default value is same as schedule period.
The schedule period is specified using the schedule period
command. You must specify this value before scheduling an
MPLS LSP monitor instance start time.
Specifies the amount of time, in seconds, during which all
of the operations are scheduled to run. All operations are
scheduled equally spaced throughout the schedule period.
Use the frequency command to specify how often the entire
set of operations is performed. The frequency value must be
greater than or equal to the schedule period.
You must specify this value before scheduling an MPLS LSP
monitor instance start time.
Specifies the time when the MPLS LSP monitor instance
starts collecting information. You must specify the scheduled
time; otherwise, no information is collected.