Glas Craft MH II User Manual page 47

9.
Turn on hose control:
a. Push in the green button.
b. Press either up or down arrow buttons on the
controller until desired temperature setting
is achieved.
10.
Turn on the ISO & POLY Heaters.
Green Power Button
NOTE
Turn transfer pump air regulator on slowly. Pumps
should cycle slowly until hoses are full of material.
WARNING
Straighten hose out flat, to avoid uneven heating and
damage to internal wiring of the hose assembly.
Operation
11.
For Programing
Use Only
Up & Down
Buttons
Green Power
On Button
NOTE
Allow enough time for hose to warm up (approximately
30 minutes). Remember that the heated hose does not
have a delta rating. The heated hose's function is to main-
tain the heat generated by the primary heaters during sys-
tem operation, and preheat material during initial start-up.
The hose should be set to maintain a temperature close to
the set point of the primary heaters.
NOTE
To see the actual temperature of the liquid in the hose, push
the blue button once and release. The actual temperature
will then be displayed for 10 seconds.
12.
NOTE
Allow enough time for the material to be heated
(approximately 3-5 minutes).
13.
45
Turn on Hydraulic Power Pack
Adjust temperature to desired setting. ISO and
POLY controllers function exactly the same as the
hose controller.
Slowly adjust Hydraulic PRESSURE KNOB clockwise
on the system to desired pressure.
Pressure Knob