Optional Transfer Pump Installation / Air Dryer Kit - Glas Craft MH II User Manual

Optional Transfer Pump Installation
P/n: 17661-01
Optional Air Dryer Kit
P/n: 23410-00 should be installed on the ISO material
drum. Replacement cartridge pn: 23409-00.
Installation
1.
2.
3.
Connect filter assemblies to transfer pumps.
Note:
4
. Connect air lines:
1) Manifold @ unit to bottom regulator
2) Side regulator port on ISO drum to
5.
Connect material hoses to material
pump inlet fittings on the unit and to
the outlet fittings at filter assemblies.
41
Remove large drum bunghole cover and
install material transfer pump bung adapter.
Carefully lower the transfer pump into the
drum until it touches the bottom of the drum.
Raise the pump 1/4 to 1/2 inch and tighten
bung adapter securely.
Connect regulator assemblies to transfer
pumps.
Replacement filter p/n: 17975-01. Replacement
gasket p/n: 294.
port on ISO drum.
air port on POLY drum.