Glas Craft MH II User Manual page 46

2.
Remove ISO & POLY side blocks from gun.
MAKE SURE VALVES ARE OFF!
PROBLER
PROBLER P2
3.
Place separate clean containers under each indi-
vidual side block. Slowly open material valves
(black arrow forward) on each side block to allow
trapped air to escape the hose and material to flow
into the containers until all air is purged from the
material system.
Operation
NOTE
Remember to dispense one to two gallons of material
to clear the system of grease and plasticizer that was
used during factory testing.
4.
Close manual material valves. Material pressure
gauges should now register approximately equal
pressure.
5.
Dispose of waste material properly and in accor-
dance with chemical suppliers instructions and
local, state and federal regulations.
NOTE
Before re-assembling Side Blocks, lubrication can be
applied by dabbing a white lithium grease into holes in-
side of Gun Front Housing and wiping grease over Side-
Block Seals. Grease will purge itself when air valve is
turned on at Gun and Gun is triggered.
6.
Clean and lubricate Side Blocks and Seals thor-
oughly and re-assemble on Gun. Make certain that
Side Block Screws are tighten securely.
7.
Refer to material manufacturers operating instruc-
tions for proper preparation of material, i.e, mixers,
etc.
8.
Turn main power Switch to ON position.
44