Glas Craft MH II User Manual page 41

Assembly Instructions
NOTE
The GlasCraft System is factory
questions arise concerning air or electrical connections,
please refer to illustrations located in the forward portion
of this User Manual or contact your GlasCraft distribu-
tor.
Fluid Line Connection
The material hoses that bring Isocyanate and Poly-
ol chemicals and the air from the machine to the gun
should be connected as follows.
Required Tools:
Opened - end wrenches - 5/8", 3/4" , 13/16"
1.
Lay hoses out straight.
2.
Couple hoses together with supplied union fittings
and tighten finger-tight.
3.
a. Hold crimp fitting hex (3/4"), and union fitting
together, allowing the hose to hold it's natural line.
b. Using the appropriate wrench (A-side 3/4" / B-side
13/16") tighten swivel fitting to union, not allowing
crimp fitting or union to turn. Repeat on opposite
side of union.
This practice is required on all connection
points.
1) Hose @ machine
2) Hose @ gun
3) Adding additional hose sections
4.
Plug hoses together, The TRU-FLOW hose plugs are
a twist-lock design.
a. Push plugs together.
b. Twist to lock position.
Once connections are made, tape connections
well enough to keep plugs from coming undone,
damaged, etc.
Installation
assembled. If any
39