Advertisement
tone, and the light will stop flashing to confirm
the remote has been linked to the Alarm. The
alarm unit will now respond to the remote.
4.
Replace the battery compartment cover on the
main alarm unit and secure the screw. The
alarm is now in standby mode.
OPERATING IN ALARM MODE
1. Locate the ALARM / CHIME switch on the side
of the alarm.
2. Slide the
switch to ALARM mode.
Arming the Alarm:
1. Point the remote control at the front of the alarm
and press the ARM button. The alarm will sound
a tone and the red indicator light will flash. There
will be a 45 second exit delay before the unit is
armed. The delay allows time for you to leave
the protected area without triggering the alarm.
2.
When motion is detected, the alarm unit
will sound a short time and a red light will
flash. The alarm will activate after 30 seconds.
The siren will sound for 30 seconds (unless
disarmed by the remote) and then turn off.
After 15 seconds the alarm will check for motion.
If motion is detected, the siren will sound again.
The cycle will repeat until the unit is disarmed
with the remote.
Disarming the Alarm:
1. When returning to the protected area, the unit
will beep once if motion is sensed.
2.
Point the remote control at the front of the
alarm unit and press the DISARM button within
30 seconds to disarm the alarm.
3. If
the disarm button is not pressed within 30
seconds, the alarm will sound. During the entrance
delay, the red indicator light will flash. Use the
remote control at any time to deactivate the alarm.
Note:
To test, a cloth can be used to cover the
alarm to reduce risk of hearing damage.
OPERATING IN CHIME MODE
The chime is used to notify you when motion is
sensed in the area.
1.
Locate the ALARM/ CHIME switch on the side
of the remote.
2. Slide the
ALARM/CHIME switch to CHIME mode.
Activating the Chime:
To activate the chime point the remote control at the
alarm and press the ARM button. The chime will
sound immediately and again when motion is sensed.
Deactivating the Chime:
To deactivate the chime point the remote control at
the alarm and press the DISARM button.
Panic Feature:
For immediate alarm with no delay, point the
remote at the front of the alarm and press and hold
the ARM and DISARM buttons on the remote
control for 2 seconds. To turn off the panic alarm,
point the remote at the front of the alarm and press
the DISARM button.
TESTING
MOTION SENSOR
OPERATION
1.
Set the
remote to CHIME mode and press the
ARM button; the chime will sound once.
2. After the initial
chime, wait 15 seconds and then
wave your hand in front of the sensor. If the chime
sounds immediately, the sensor is working correctly.
3.
To discontinue the test, point the remote at the
front of the alarm and press DISARM. Set the
remote to ALARM mode.
MAINTENANCE
To clean the unit housing, use a soft cloth slightly
dampened with water and wipe dry. Do not use
chemical agents as this may damage and
discolor the unit.
Warning:
Risk of
personal injury
Prolonged exposure to alarm siren may cause
permanent hearing loss.
Battery Warning:
Remove batteries before storing the Alarm for
extended periods.
Advertisement
