Wieland samos PRO COMPACT Manual page 184

Delete any bytes not required
You can delete bytes pre-allocated by samosPLAN5+ that you do not require by clicking on
them with the mouse.
 Launch samosPLAN5+.
 Read the hardware configuration, including the SP-EN-ETC gateway.
Instructions: Software manual, chapter "Connect with the safety control"
 Switch to the Gateway view.
 Click on the byte you do not need and wish to delete.
 Click on the Delete icon in the command bar.
You will find further information about how to configure the process diagram here:
Configuration of gateways [ch. 5, p. 35]
•
• Software manual
Structure of the data block
The input data block consists of 50 bytes (byte 0 to 49) of data that is transferred from the
EtherCAT network to the SP-EN-ETC gateway. The content of the data bytes does not meet the
requirements of a safety system. The values are only current as long as the gateway to the
EtherCAT network is connected and the gateway status is Operational. As soon as the state
machine of the gateway adopts a state other than Operational, this data is set to zero.
Also see:
Table 125: Input data block 1–5 of the SP-EN-ETC module to --> samosPRO COMPACT
Input data
block 1
Byte 0 Byte 0
Byte 1
Byte 2
Byte 3
Byte 4
Byte 5
Byte 6
Byte 7
Byte 8
Byte 9 Byte 9
Lengt 10 byte
h
Wieland Electric GmbH | BA000970 | 11/2016 (Rev. F)
Gateway state machine [ch. 11.3, p. 172]
Input data
block 2
Byte 10
Byte 19
10 byte
EtherCAT Gateway
Input data Input data
block 3 block 4
Byte 20 Byte 30
Byte 29 Byte 39
10 byte 10 byte
Input data
block 5
Byte 40
Byte 49
10 byte
184