Advertisement
Nucleus Name
DS_ANAB_SoftwareVersionDiagnosticsGet
Nucleus Number
1110
Description
Get the software version of the diagnostic software of the analogue board
User Input
None
Example
DS:> 1110
111000: Diagnostics application version : 11.00.13
Test OK @
Nucleus Name
DS_ANAB_ChecksumProgram
Nucleus Number
1111
Description
Check the checksum of the several partitions by recalculating and comparing partition
checksums
User Input
None
Example
DS:> 1111
BootCode checksum is: 0xBABE6240, which is correct
Diagnostics checksum is : 0xBABEBEAD, which is correct
Download checksum is: 0xBABEA6B7, which is correct
Application checksum is : 0xBABEB277, which is correct
111100:
Test OK @
Nucleus Name
DS_ANAB_VideoRouting
Nucleus Number
1112
Description
Perform the routing of the video paths on the analogue board
User Input
The user has to input the correct parameter for the routing (see table 'video routing'
below).
Example
DS:> 1112
00111200:
Test OK @
Video routing paths (Europe)
Path ID
Description
0
Input signal is VIDEO(CVBS) from digital board and will be re-routed back to the digital
board.
1
Input signal is from FRONT VIDEO(CVBS) IN and will be routed to the digital board.
2
No Routing.
3
Input signal is from FRONT S-VIDEO(Y/C) and will be routed to the digital board.
4
No Routing.
5
Input signal is CVBS from SCART1 and will be routed to the digital board.
6
Input signal is CVBS from SCART2 and will be routed to the digital board.
7
Input Signal is CVBS from Digital Board and it will be routed to Scart1 and Scart2.
8
Input signal is VIDEO(CVBS) from ANTENNA IN and will be routed to SCART2.
9
Input signal is VIDEO(CVBS) from SCART1 and will be routed to SCART2.
10
Input signal is VIDEO(CVBS) from SCART2 and will be routed to SCART1.
11
Signal path is routed Fast Blank from Scart2 pin16 and will be routed SCART1 pin16
12
Input Signal is YC from Digital Board and it will be routed to SCART1.
13
14
No Routing.
15
Input Signal is CVBS from TUNER and it will be routed to Digital .
16
No Routing.
17
Input Signal is routed from digital board YC to REAR S-VIDEO(YC) OUT
18
Signal path is routed from digital board RGB to RGB SCART1 and from digital board
CVBS to digital board CVBS.
19
No Routing.
20
Input RGB Signal is routed from Digital Board to SCART1(RGB),Input CVBS Signal
from Digital Board to Digital Board and Fast Blanking Signal from SCART2 to
SCART1.
21
Input Y/C Signal from Digital Board is routed to Rear Y/C Connector and Input Y/C
Signal from Front Y/C connector is routed to Digital Board.
Video routing paths (NAFTA)
Path ID
Description
0
No Routing.
1
Input signal is from FRONT VIDEO(CVBS) IN and will be routed to the digital board.This
routing is same as the above path id.
Diagnostic Software
DVDR730/0x
5.
EN 59
Advertisement
