Advertisement
4.1.3
Digital Board
-
Unplug the IDE cable that connects to the card reader (1),
see picture 4-8
-
Remove the 2 screws (2) that fix the card reader
-
Remove the card reader PCB (3)
-
Remove the 3 screws (4) that fix the bracket of the card
reader, see picture 4-9.
-
Remove the 4 screws (5) that fix the Digital Board, see
picture 4-10, and turn the Digital Board to the required
service position, see picture 4-11
Figure 4-8
Figure 4-9
5
5
Figure 4-10
Mechanical Instructions
1
3
2
2
1
4
4
4
5
5
DVDR730/0x
Figure 4-11
4.1.4
Basic Engine
-
Remove the tray, see picture 4-2
-
Remove the 4 screws that fix the drive, see picture 4-12
Figure 4-12
4.1.5
Analog Board
-
Remove the 3 screws (1) that fix the back plate to the
bottom plate, see picture 4-13
-
Remove the 4 screws (2) that fix the Analog Board to the
bottom plate
-
Remove the Fan assy by releasing the fixing screw (3)
-
Remove screw safety holder (4)
-
Unlock the two snaps hooks at the left and right (5), see
picture 4-14, and pull the board and backplate out gently
(6)
-
Turn the PCB in the service position (7), see picture 4-15
2
4
1
Figure 4-13
4.
EN 39
2
2
2
1
1
3
Advertisement
