Installing The Microsd Card; Bench Testing; Analog Video Connections; Connecting Power - FLIR FC-Series ID Installation Manual

1 Camera Installation
1.4.2
The FC-Series ID camera has local storage (on the camera) flash memory to store images captured
as a result of an alarm action. However, these images are lost during a reboot or power cycle. When
a customer supplied microSD card (64 GB) is installed, local storage is persistent through reboots
and power cycles.
Pull back cage to unlock
Lift edge to open
1.4.3
Note
If the camera is to be mounted on a pole or tower or other hard-to-reach location, it may be a good
idea to connect and operate the camera as a bench test at ground level prior to mounting the
camera in its final location.
Connect the power, Ethernet, and video, and confirm that the video can be displayed on a monitor
when the power is turned on. For configuration and basic setup information using the onboard web
server, refer to
1.4.4
The primary analog video connection of the camera is a BNC connector. The video cable used
should be rated as RG-59/U or better to ensure a quality video signal.
Note
Insert the cables through the cable glands on the enclosure before terminating and connecting them.
In general, terminated connectors will not fit through the cable gland. If a terminated cable is
required, it is possible to make a clean and singular cut in the gland seal to install the cable.
1.4.5
The camera can be powered with a conventional Vac or Vdc
power supply, rather than PoE+. Prior to making any connections,
ensure the power supply or circuit breaker is switched off.
427-0089-00-12 Version 100

Installing the microSD Card

Bench Testing

Camera Bench Test, pg. 23

Analog Video Connections

Connecting Power

Table 1-2: Power Connections
Chassis
1
Vac or Vdc
2
Vac or Vdc
3
Inset microSD card
for specific details.
(–)
(+)
July 2016
Close cage,
press down and
push forward to lock
1
2
3
Figure 1-8: Power Connector
13