FLIR FC-Series Quick Connect Manual

Hide thumbs Also See for FC-Series:

https://www.supplychimp.com/

3 mm hex

key

For installations that are using the Concealed Cable Mounting Arm, refer to the

installation manual for instructions:

FLIR FC-Series Installation Manual (427-0073-12-12)

Caution!

Except as described in this guide, do not disassemble the FC-Series camera.

Damage to the camera can occur as the result of careless handling or

electrostatic discharge (ESD).

Prior to making any connections, ensure the power is switched off.

Note

Power: Power Over Ethernet Plus (PoE+) or 14 - 32 Vdc or 18 - 27 Vac

Power terminal blocks: wire size from 16 AWG to 20 AWG

Analog Video Cable: BNC-terminated RG-59/U solid-center coax cable

Accessory I/O Cable: wire size 26 AWG, stranded (1 mm diameter including

insulation)

427-0073-12-28 Rev 110

Quick Connect Guide

Items Included in Kit

FC-Series Camera

2.4 mm slotted

screwdriver

May 2015

Table of Contents

Do you have a question about the FC-Series and is the answer not in the manual?

Page 1 FLIR FC-Series Installation Manual (427-0073-12-12) Caution! Except as described in this guide, do not disassemble the FC-Series camera. Damage to the camera can occur as the result of careless handling or electrostatic discharge (ESD). Prior to making any connections, ensure the power is switched off.
Page 2 https://www.supplychimp.com/ Step 1 Remove cover: Using 3 mm hex key, loosen four captive screws. Removal of sunshield not necessary. Access captive screws through slots in sunshield. Step 2 Install cables through sealing gland: Re-tighten gland nut after installation is completed. Fill any unused hole with Gland nut orange plug.
Page 3 https://www.supplychimp.com/ Step 4 Terminate cables: Connection Purpose 3-pin Jumper Lens heater on/off Analog video test point Analog video 3-pin Terminal AC/DC Power Ethernet PoE power, communications, IP video stream 6-pin terminal J8 General purpose I/O (GPIO) Reserved for future use Do not connect Table 1-1: Power Connector Chassis...
Page 4 FLIR requires a grounding strap anchored to the grounding lug and connected to the nearest earth-grounding point. Before installing the FC-Series camera you should read and understand the following documents which provide details regarding mechanical dimensions and installation safety.