Advantech TREK-688 User Manual page 9

Connecting the Power Cable
1.
2.
3.
4.
5.
6.
Safety Precaution - Static Electricity
Follow these simple precautions to protect yourself from harm and the products from
damage.
To avoid electrical shock, always disconnect the power from your PC chassis
before you work on it. Don't touch any components on the CPU card or other
cards while the PC is on.
Disconnect power before making any configuration changes. The sudden rush
of power as you connect a jumper or install a card may damage sensitive elec-
tronic components.
This product is intended to be supplied by a Listed DC power source, rated
9~32Vdc, 7A minimum and Tma 55 degree C, if need further assistance with
purchasing the DC power source, please contact Advantech for further information.
Warning!
1.
TREK-688 User Manual
Disconnect the vehicle battery.
Connect the green wire to the vehicle`s negative power source.
NOTE see the vehicle Owner`s Manual for specific wiring information.
Connect the red wire of Fuse Box in passenger compartment to
vehicle`s positive power source. Connect the black wire to the
vehicle`s negative power source. Then Fuse Box secured to connector.
Insert the female connector of Fuse Box to the male connector of
TREK-688 vehicle system. Connect the Orange wire to the vehicle`s
ignition switch.
Ensure the wiring connections created are sufficiently insulated from
each other.
Re-connect the vehicle battery.
Insert the power cable connector into TREK-688 computing system
power port. Align the keyway on the power connector with the notch on
the vehicle computer`s power port.
CAUTION
Do not open the cover on the front side as illustration as below before
turning off the power.
Input voltage rated: 9 ~ 32 Vdc.
8