Auto-Retrieve Flag - Avaya 1140E Software User's Manual

Figure 66: Speed Dial List screen
The Speed Dial List screen displays all the Speed Dial List entries provisioned. The displayed
Speed Dial List items are based on the provisioned list as well as the current Idle/Mid-call state of
the IP Deskphone. After you invoke the Speed Dial List while the IP Deskphone is idle, only Speed
Dial List entries that are configured to IDLE are displayed. Similarly, only items marked as MID
CALL are displayed if the Speed Dial List is invoked while the IP Deskphone is in a call.
The following are the options available for the Speed Dial List screen:
• Dial — invokes the selected speed dial.
• Exit — screen dismisses without invoking a Speed Dial List entry.
Related links
Speed Dial List on page 245

Auto-Retrieve flag

If you enable the Auto-Retrieve behavior on a Speed Dial key or Speed Dial list entry that is
invoked, and place a call on hold to invoke the current key/entry, the IP Deskphone attempts to un-
hold the call after the key or entry call completes.
For example:
• A is talking to B when A invokes their Speed Dial List and selects an entry.
• Selection/invocation of a Speed Dial List entry places the A-B call on hold and places an
outgoing call to the URI specified in the Speed Dial List entry; for example, C.
• When the A-C call completes, if the Auto-Retrieve flag is enabled for the Speed Dial, then the
IP Deskphone attempts to take call A-B off hold. This may not always happen if the IP
Deskphone receives another call during the A-C call, or if the A-B call state is changed while A-
C is active.
The Auto-Retrieve behavior is added to regular speed dial keys instead of speed dial list entries. To
make sure that this flag is configured for programmed speed dial keys, the Enable Auto-Retrieve
screen shown in the following figure appears as the last step in Speed Dial Key configuration.
August 2017 Avaya 1140E IP Deskphone with SIP Software User Guide
Comments on this document? infodev@avaya.com
Speed Dial List
247