Advertisement
Beadboard Peg Shelf
Note: This hanging system is meant for drywall/wood stud mounting only. If wall are concrete, brick or
plaster, please consult your local hardware store for assistance. For safety and ease of mounting,
installation is recommended using two people.
Parts Included:
A
Wall-mount Bracket
1PCS
Tools required for mounting (not included):
Phillips screwdriver, Level, Pencil, Tape measure
Mounting Instructions:
11. Hold the shelf against the wall and at your desired location. Use a level to ensure the product isn't
tilting to one side. Using a pencil, gently mark the wall along the top and side edges (midway down
each side) of the shelf. Remove the shelf and gently face down on a soft surface.
12. Your product should have a Wall-mount bracket taped to the back of the shelf. If it has come loose,
align its angle edge with the product-mounted bracket and slide it onto the product-mounted bracket.
13. Using a tape measure, measure the distance from the top edge of the shelf to the bottom edge of
Wall-mount bracket. Move to the wall and starting with the horizontal line made in Step #1, measure
the distance down and mark the wall with the pencil.
14. Return to the shelf and measure the distances from each side's outer edge to the edge of the
recessed section. Move to the wall and starting with the vertical lines made in Step #1, measure the
lengths in from each side of the shelf and mark the wall with the pencil.
15. The horizontal line made in Step #3 denotes the bottom boundary for the placement of the wall-mount
bracket. The vertical lines made in Step #4 denote the outer boundaries for the wall-mount bracket.
16. Within the boundary lines made in Steps #3 & #4, use a pencil to mark the location of any wall studs.
(Note: It is best to mount the Wall-mount Bracket to at least (1) stud.)
17. Hold the Wall-mount bracket (A) against the wall with the angled edge pointing up and away from the
wall. Align the bottom edge of the bracket with the horizontal line made in Step #3. Keeping the
bracket within the marks made in Step #4, if possible, align one of the pre-drilled holes on the bracket
to the location of a wall stud. Use a level to ensure the bracket is not tilting to the side and then use a
Phillips screwdriver to insert a Stud Screw (B) through the pre-drilled hole on the bracket and into the
wall stud. Do not fully tighten the screw; the bracket should be able to freely rotate around the screw.
18. Level the bracket and then mark the wall through the other pre-drilled hole. This mark on the wall is
the insertion point for the remaining mounting hardware. Rotate wall bracket slightly to see your mark.
B
C
Toggle Screws
Toggles Anchors
2PCS
D
Stud Screws
2PCS
2PCS
Advertisement
