Roland Color CAMM PC-50 User Manual page 11

When CR-CY, MG, YE, and BK ribbon cartridges are used for printing, the PC-50 performs printing in the following color sequence:
MAGENTA (M) CYAN (C)
Follow the steps below to install and change the ribbon cartridges.
1
When data is sent, the
carriage first specifies
MAGENTA and stops.
2
First install the MAGENTA
(CR-MG) ribbon cartridge.
3
When the MAGENTA
printing is finished, the
carriage indicates the next
color (CYAN) and stops.
4
Replace the MAGENTA (CR-
MG) cartridge with the CYAN
(CR-CY) cartridge, then press
the CHANGE key.
5
When the CYAN printing is
finished, the carriage indicates
the next color (BLACK) and
stops.
6
Use the same procedure to change to the BLACK (CR-BK) and YELLOW (CR-YE) ribbon cartridges.
* If any of the four colors (C, M, Y, or K) is not used, the PC-50 does not stop at that color.
Special color Printing
This is used to add emphasis to some areas, or when printing with limited colors. Special-color ribbon cartridges are sold separately.
When the ribbon cartridge needs to be changed, the carriage stops at SPECIAL COLOR.
For more details, please refer to the operator's manual for the software driver, or to online help.
BLACK (K) YELLOW (Y)
MAGENTA
(CR-MG)
CYAN
(CR-CY)
5 Basic Operation
The CHANGE LED
blink
Press the CHANGE key.
The CHANGE LED
blink
The CHANGE LED
blink
9