Installing The Rcp; Preparing The Rcp For Rack Mounting (Optional) - Canon BU 45 User Manual

Installing the RCP

The RCP can be installed as either a desktop or rack-mounted configuration. In either
case, the touch screen must be secured to the RCP and connected before the RCP can
be configured and used.

Preparing the RCP for Rack Mounting (Optional)

For a rack-mounted installation, use the RCP Rack Mount Kit (Telemetrics Part No.
XXXX).
Contact your Telemetrics representative for information on obtaining an
RCP Rack Mount Kit.
1.
Obtain the RCP Rackmount kit.
2.
If the RCP is currently being used in the desktop configuration, disconnect
the RCP power cable. Then disconnect the power, VGA, and USB leads at
the end of the touch screen interface cables from their respective connectors
on the touch screen and the RCP.
3.
Secure the RCP Rack Adaptor to the sides of the RCP using the six flat head
cap screws, ensuring that the top surface of the RCP is flush and parallel with
the top surface of the RCP Rack Adaptor.
4.
Obtain the appropriate screen interface cable and connect the power, VGA,
and USB leads to their connectors on the RCP (refer to page 20 for details).
5.
Route the screen interface cable through the panel grommet.
6.
Connect the power and VGA leads to their connectors on the touch screen
(refer to page 19 for details).
7.
Mount the RCP Rack Adaptor and the Rack Mount (if used).
If the touch screen will be mounted on the RCP Rack Adapter,
use the 2-foot screen interface cable. If the touch screen will be
flush-mounted on the RCP Rack Mount, use the 7-foot screen
interface cable.
Installation and Setup
17