Connecting the Touch Screen to the RCP
After the touch screen is attached, it should be connected to the RCP using the touch
screen power and communication cables that are provided.
1.
Connect the end of the touch screen power cable with the smaller connector
to the power terminal on the touch screen (Figure 9).
2.
Connect the end of the touch screen communication cable with the single
connector to the VGA terminal on the touch screen (Figure 9).
Figure 9 Connections at the Touch Screen
The end of the communication cable with the single VGA
connector must be connected to the touch screen. The two
connectors at the other end must be connected to the RCP.
Connect to Touch Screen
Installation and Setup
Power Cable
Communication Cable
Connect to RCP
19