Sip Paging: One Adapter - Algo 8301 Installation/Configuration Manual

SIP Paging: One Adapter

The 8301 Paging Adapter & Scheduler can be registered as a third
party SIP extension with a hosted or enterprise Communications
Server supporting 3
To register the adapter with the SIP server, use the Basic Settings >
SIP tab in the web interface to enter the Communication Server IP
address, extension, username, and password. This information will be
available from the IT Administrator.
If VLAN is used, navigate to the Advanced Settings > Network tab
to set VLAN options.
(Note, once the adapter is using VLAN you will need to be on the same
VLAN to access the web interface.)
The adapter may now be accessed by dialling its assigned extension
from a telephone, device, or client. The adapter will auto-answer, play
the default WAV pre-announce tone, and allow voice paging until
disconnected.
There are a number of configurable adapter options:
The best voice paging quality and intelligibility will be obtained using
the G.722 wideband audio codec. Most current IP telephones support
G.722 which is sometimes referred to as "HD" voice or audio.
Document 90-00070
2017-08-30
Page 14
rd party SIP endpoints.
 Increase or Decrease Speaker Volume
 Enable AGC (automatic gain control)
 Customize pre-announce tone WAV file
Algo Communication Products Ltd
4500 Beedie St Burnaby BC Canada V5J 5L2
www.algosolutions.com
8301 Paging Adapter & Scheduler (FW 1.5)
support@algosolutions.com
(604) 454-3792