Table of Contents
Advertisement
about the installation of the anti-tilt
protection.
1. Install the anti-tilt protection 317 -
322 mm down from the top surface of
the appliance and 80 - 85 mm from
the side of the appliance into the
circular hole on a bracket. Screw it
into the solid material or use
applicable reinforcement (wall).
2. You can find the hole on the left side
14.11 Electrical installation
This appliance is supplied with a main
plug and a main cable.
80-85
mm
317-322
mm
at the back of the appliance. Lift the
front of the appliance and put it in the
middle of the space between the
cupboards. If the space between the
bench cupboards is larger than the
width of the appliance, you must
adjust the side measurement to
centre the appliance.
If you changed the
dimensions of the cooker,
you must align the non-tip
device correctly.
CAUTION!
If the space between the
bench cupboards is larger
than the width of the
appliance, you must adjust
the side measurement to the
centre of the appliance.
WARNING!
The manufacturer is not
responsible if you do not
follow the safety precautions
from Safety chapters.
WARNING!
The power cable must not
touch the part of the
appliance shown in the
illustration.
ENGLISH
27
Advertisement
Table of Contents
