Troubleshooting - Electrolux EKM51302OX User Manual

Hide thumbs

Advertisement

Table of Contents
22
www.electrolux.com
1. Open the door until it is at an angle of
approximately 30°. The door stands
alone when slightly open.
30°
2. Hold the door trim (B) at the top edge
of the door on both sides and push
inwards to release the clip seal.
2
B
3. Pull the door trim to the front to
remove it.
WARNING!
When you take out the
glass panels the oven
door tries to close.
4. Hold the top edge of the door glass
panels and pull them up one by one.
5. Clean the glass panel with water and
soap. Dry the glass panel carefully.
When the cleaning is complete, install
the glass panels and the oven door. Do
the above steps in the opposite
sequence. Install the smaller panel first,
then the larger.

13. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
1
CAUTION!
The screen with a printing on
the inner glass panel must
face the inner side of the
door.
CAUTION!
Make sure that after
installation the surface of the
frame of the glass panel on
the screen with a printing is
not rough when you touch it.
CAUTION!
Make sure that you install
the internal glass panel in
the appropriate seats.
12.4 Replacing the lamp
Put a cloth on the bottom of the interior
of the appliance. It prevents damage to
the lamp glass cover and the cavity.
WARNING!
Danger of electrocution!
Disconnect the fuse before
you replace the lamp.
The lamp and the lamp glass
cover can be hot.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box
or deactivate the circuit breaker.
The back lamp
1. Turn the lamp glass cover
counterclockwise to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300
°C heat-resistant lamp.
4. Install the glass cover.

Advertisement

Table of Contents
loading

  Related Manuals for Electrolux EKM51302OX

Table of Contents