Table of Contents
Advertisement
14.5 Electrical installation
The manufacturer is not responsi-
ble if you do not follow safety pre-
cautions from the chapter "Safety
information".
This appliance is supplied without a main
plug and a main cable.
Applicable cable type: H05 RR-F with ad-
equate cross-section.
WARNING!
Before you connect the mains ca-
ble to the terminal, measure the
voltage between phases in the
house network.
Then, refer to the connection label
at the back of the appliance to
use the correct electrical installa-
tion
This order of steps prevents from
installation errors and damage to
the electrical components of the
appliance.
How to install the anti-tilt protection
80-85
1.
mm
317-
322 mm
2.
3.
4.
5.
Set the correct height and area for
the appliance before you attach the
anti-tilt protection.
Make sure that the surface behind the
appliance is smooth.
Install the anti-tilt protection 317 - 322
mm down from the top surface of the
appliance and 80 - 85 mm from the
side of the appliance into the circular
hole on a bracket. Screw it into the
solid material or use applicable rein-
forcement (wall).
You can find the hole on the left side
at the back of the appliance. See the
illustration.
If you changed the dimensions of the
cooker, you must align the non-tip
device correctly.
If the space between the bench
cupboards is larger than the width
of the appliance, you must adjust
the side measurement to center
the appliance.
The power cable must not touch
the part of the appliance shown in
the illustration.
ENGLISH
25
Advertisement
Table of Contents
