Download Print this page

Electrical Installation - Electrolux EKS61300OX Installation

Free standing cooker

Advertisement

You must install the anti-tilt protection. If
you do not install it, the appliance can tilt.
Your appliance has the symbol shown on
the picture (if applicable) to remind you
about the installation of the anti-tilt
protection.
1. Install the anti-tilt protection 232 -
237 mm down from the top surface of
the appliance and 110 - 115 mm from
the side of the appliance into the
circular hole on a bracket. Screw it
into the solid material or use
applicable reinforcement (wall).
2. You can find the hole on the left side
at the back of the appliance. Lift the
front of the appliance and put it in the
middle of the space between the
cupboards. If the space between the
bench cupboards is larger than the
width of the appliance, you must
110-115
mm
232- 237
mm
adjust the side measurement to
centre the appliance.
If you changed the
dimensions of the cooker,
you must align the non-tip
device correctly.
CAUTION!
If the space between the
bench cupboards is larger
than the width of the
appliance, you must adjust
the side measurement to the
centre of the appliance.

14.5 Electrical installation

WARNING!
The manufacturer is not
responsible if you do not
follow the safety precautions
from Safety chapters.
This appliance is supplied without a main
plug or a main cable.
Applicable cable type: H05 RR-F with
adequate cross-section.
WARNING!
Before you connect the
mains cable to the terminal,
measure the voltage
between phases in the
house network. Then, refer
to the connection label at the
back of the appliance to use
the correct electrical
installation. This order of
steps prevents from
installation errors and
damage to the electrical
components of the
appliance.
WARNING!
The power cable must not
touch the part of the
appliance shown in the
illustration.
ENGLISH
23

Advertisement

loading