Names And Functions Of Parts - Oriental motor DSC Series Operating Manual

3.4 Names and functions of parts

„ Motor
Output shaft
„ Speed controller
Operation panel
Name
Display
(4-digit LED)
Operation
panel
Operation keys
POWER LED
(Green)
ALARM LED
(Red)
Motor connector
(CN3)
Main circuit connector
(CN1)
Control circuit connector
(CN4)
Sink logic / Source logic
select switch (SW1)
DIN lever
Protective Earth Terminal
Mounting holes
Gearhead
(four locations)
Display
Operation keys
POWER LED
(Green)
ALARM LED
(Red)
Main circuit connector
(CN1)
DIN lever
The rotation speed, parameter, alarm and others are shown on the
display.
These keys are used to switch the operation mode, set the operation
data or change the parameter.
This LED is lit while the AC power is supplied to the speed controller.
This LED blinks while an alarm generates.
Connects the motor connector.
Connects the AC power supply, capacitor and FG.
Connects the control DC power supply and I/O signals.
This switch is used for switching the input signal between sink logic
and source logic modes.
Mounts the speed controller to a DIN rail.
The speed controller can be mounted using screws.
Tachogenerator
Motor
Protective film
(Use after removing the protective film.)
Motor connector
(CN3)
Control circuit connector
(CN4)
Sink logic/Source logic
select switch (SW1)
Description
Preparation
Rear view of the motor
Reference
page
p.26
p.18
p.32
p.13
p.17
p.11
−7−