Double Insulated Tools: Tools With Two Prong Plugs; Extension Cords - Chicago Electric 65519 Owner's Manual & Safety Instructions

GROUNDING
FROM INCORRECT GROUNDING
WIRE CONNECTION:
Check with a qualified electrician if
you are in doubt as to whether the
outlet is properly grounded. Do not
modify the power cord plug
provided with the tool. Never
remove the grounding prong from
the plug. Do not use the tool if the
power cord or plug is damaged. If
damaged, have it repaired by a
service facility before use. If the
plug will not fit the outlet, have a
proper outlet installed by a qualified
electrician.
Double Insulated Tools: Tools with Two
Prong Plugs
1. Tools marked "Double Insulated" do not
require grounding. They have a special
double insulation system which satisfies
OSHA requirements and complies with
the applicable standards of Underwriters
Laboratories, Inc., the Canadian Standard
Association, and the National Electrical
Code.
(See Outlets for 2-Prong Plug.)
2. Double insulated tools may be used in
either of the 120 volt outlets shown in the
Page 8
TO PREVENT ELECTRIC
SHOCK AND DEATH
For technical questions, please call 1-888-866-5797.
preceding illustration.
(See Outlets for 2-Prong Plug.)

Extension Cords

1. Grounded tools require a three wire
extension cord. Double Insulated tools
can use either a two or three wire extension
cord.
2. As the distance from the supply outlet
increases, you must use a heavier gauge
extension cord. Using extension cords with
inadequately sized wire causes a serious
drop in voltage, resulting in loss of power
and possible tool damage. (See Table A.)
3. The smaller the gauge number of the wire,
the greater the capacity of the cord. For
example, a 14 gauge cord can carry a
higher current than a 16 gauge cord. (See
Table A.)
4. When using more than one extension cord
to make up the total length, make sure each
cord contains at least the minimum wire size
required. (See Table A.)
5. If you are using one extension cord for more
than one tool, add the nameplate amperes
and use the sum to determine the required
minimum cord size. (See Table A.)
6. If you are using an extension cord outdoors,
make sure it is marked with the suffix "W-A"
("W" in Canada) to indicate it is acceptable
for outdoor use.
7. Make sure the extension cord is properly
wired and in good electrical condition.
Always replace a damaged extension cord
or have it repaired by a qualified electrician
before using it.
8. Protect the extension cords from sharp
objects, excessive heat, and damp or wet
areas.
Item 65519