Table of Contents
Advertisement
Main Level
Fan Mode
Back Light
Fixture Hours
Information
Version
UID
Reset
Factory
Configuration (DMX)
Use control configurations to operate the product with a DMX controller.
Control Personalities
This setting allows you to choose a particular control personality.
1.
Go to the DMX Channel main level.
2.
Select the desired personality (see table below).
Personality
1 Ch
2 Ch
3 Ch
6 Ch
•
See the
personality.
•
Make sure that the starting addresses on the various products do not overlap due to the
new personality setting.
Starting Address
Each product will respond to a unique starting address from the DMX controller. All products with the same
starting address will respond in unison.
1.
Go to the DMX Address main level.
2.
Select the starting address (001–512).
The highest recommended starting address for each DMX mode is as follows:
Personality
1 Ch
2 Ch
3 Ch
6 Ch
Page 10 of 18
Programming Levels
Auto
On
Off
Silent
10S
30S
2Min
Always On
_ _ _ _H
V_._
_ _ _ _ _ _ _ _ _ _ _ _ Shows product UID
No
Yes
Starting Address
section for the highest starting address you can select for each
Description
Sets the fan to auto mode
Sets the fan to always on
Sets the fan to always off
Sets the fan to silent
Turns off display backlight after 10
seconds of inactivity
Turns off display backlight after 30
seconds of inactivity
Turns off display backlight after 120
seconds of inactivity
Display backlight always on
Shows total hours the product has been
powered on
Shows current firmware version
Resets the product to factory default
settings
Channels
1
2
3
6
Address
512
511
510
507
Ovation P-56WW User Manual Rev. 4
O
PERATION
Advertisement
Table of Contents
