Qos Configuration Example - HPE OfficeConnect 1950 Series User Manual

To establish a connection to the Stelnet server:
1. Launch PuTTY.exe to enter the interface.
2. In the Host Name (or IP address) field, enter the IP address 192.168.1.40 of the Stelnet
server.
3. Click Open to connect to the server.
If the connection is successfully established, the system notifies you to enter the username and
password. After entering the username (client in this example) and password (aabbcc in this
example), you can enter the CLI of the switch.

QoS configuration example

Network requirements
As shown in
•
The traffic of the Administration department, R&D department, and Marketing department is
scheduled in the ratio of 2:1:1.
•
The rate of traffic for accessing the Internet is limited to 15 Mbps.
Figure 38 Network diagram
Admin dept.
192.168.1.0/24
Configuration procedure
1. Configure QoS policies:
a. From the navigation tree, select QoS > QoS > QoS Policy.
b. Apply a QoS policy to the incoming traffic of GigabitEthernet 1/0/2.
c. Access the details page for the QoS policy to modify the applied QoS policy as follows:
− Create IPv4 ACL 2000, and add a rule to permit packets with source IP address
− Configure the ACL as a match criterion of a class, and specify the associated behavior
d. Apply a QoS policy to the incoming traffic of GigabitEthernet 1/0/3.
e. Access the details page for the QoS policy to modify the applied QoS policy as follows:
Figure 38, configure QoS to meet the following requirements:
IP network
GE1/0/2
R&D dept.
192.168.2.0/24
192.168.1.0 and mask 0.0.0.255.
to mark the matched packets with 802.1p priority 0.
GE1/0/1
GE1/0/4
GE1/0/3
Marketing dept.
118
192.168.3.0/24