HPE OfficeConnect 1950 Series User Manual page 124

− Specify the pool name as pool1.
− Specify the subnet as 10.10.1.0/24 for dynamic allocation.
− Specify the gateway IP address as 10.10.1.1.
g. Access the advanced settings page to perform the following tasks:
− Configure the conflict detection feature to send a maximum of one ping packet.
− Specify the timeout time for the response as 500 milliseconds.
2. Configure the DHCP relay agent:
a. From the navigation tree, select Network > Links > VLAN.
b. Create VLAN 10 and VLAN 20.
c. Access the details page for VLAN 10 to perform the following tasks:
− Add GigabitEthernet 1/0/1 to the tagged port list.
− Create VLAN-interface 10.
− Assign the IP address 10.10.1.1/24 to VLAN-interface 10.
d. Access the details page for VLAN 20 to perform the following tasks:
− Add GigabitEthernet 1/0/2 to the tagged port list.
− Create VLAN-interface 20.
− Assign the IP address 10.1.1.2/24 to VLAN-interface 20.
e. From the navigation tree, select Network > Service > DHCP.
f. Perform the following tasks:
− Enable the DHCP service.
− Configure VLAN-interface 10 to operate in DHCP relay agent mode.
− Specify the IP address of the DHCP server as 10.1.1.1.
g. Access the advanced settings page to perform the following tasks:
− Enable the DHCP relay agent to record client information.
− Enable the relay agent to fresh relay entries periodically.
− Set the refresh internal to 100 seconds.
3. Configure the DHCP client:
a. From the navigation tree, select Network > Links > VLAN.
b. Create VLAN 10.
c. Access the details page for VLAN 10 to perform the following tasks:
− Add GigabitEthernet 1/0/1 to the tagged port list.
− Create VLAN-interface 10.
d. From the navigation tree, select Network > IP > IP.
e. Access the details page for VLAN-interface 10 and configure the interface to obtain an IP
address through DHCP.
Verifying the configuration
1. Access the Web interface of the DHCP server to verify that an IP address has been assigned to
the DHCP client. (Details not shown.)
2. Access the Web interface of the DHCP relay agent to verify that a relay entry exists for the
assigned IP address. (Details not shown.)
3. On the DHCP client, verify that the client has obtained the IP address assigned by the DHCP
server. (Details not shown.)
116