Table of Contents
Advertisement
Figure 25. Installing the heat sink
7. Install the M.2 solid-state drive adapter into the appropriate PCIe card slot on the system board. See
"PCIe card" on page 96.
Note: It is recommended that you install the M.2 solid-state drive adapter into the PCIe x16 card slot.
See "Parts on the system board" on page 34.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 166.
Memory module
Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
Your computer has four memory slots for installing or replacing DDR4 DIMMs that provide up to a maximum
of 64 GB system memory. When installing or replacing a memory module, use the following guidelines:
• Use 4 GB, 8 GB, or 16 GB DDR4 UDIMMs in any combination up to a maximum of 64 GB system memory.
• Do not mix ECC UDIMMs and non-ECC UDIMMs within the same system.
.
Chapter 9
Hardware installation and replacement
101
Advertisement
Table of Contents
