Table of Contents
Advertisement
b. Flex both sides of the bracket to remove the 3.5-inch internal storage drive from the bracket. Do not
touch the circuit board
Figure 71. Flexing both sides of the bracket to remove the 3.5-inch internal storage drive
4. Flex the bracket and align pins
3.5-inch internal storage drive. Then install a new 3.5-inch internal storage drive into the bracket. Do not
touch the circuit board
Figure 72. Installing the new 3.5-inch internal storage drive into the bracket
1
on the internal storage drive.
1
,
2
,
3
, and
4
5
on the internal storage drive.
on the bracket with the corresponding holes in the new
.
Chapter 9
Hardware installation and replacement
125
Advertisement
Table of Contents
