Replacing A Memory Module; Retainer Bracket For Diskette Drive; Removing The Memory Module - Lenovo 9686 Hardware Installation And Replacement Manual

5. Remove the retainer bracket from the failing diskette drive and install it on the
Figure 34. Retainer bracket for diskette drive
6. Slide the new diskette drive into the drive bay until it snaps into position.
7. Connect the flat cable to the new diskette drive.
8. Replace the front bezel.
9. Go to Chapter 4, "Completing the parts replacement," on page 47.

Replacing a memory module

This section provides instructions on how to replace a memory module.
Note: Your computer has support for two or four memory modules.
1. Remove the computer cover. See "Removing the cover" on page 13.
2. Locate the memory connectors. See "Identifying parts on the system board" on
3. Remove the memory module being replaced by opening the retaining clips as
Figure 35. Removing the memory module
new diskette drive.
Attention
Do not open your computer or attempt any repair before reading the "Important safety
information" in the Safety and Warranty Guide that was included with your computer. To
obtain a copy of the Safety and Warranty Guide, go to the Support Web site at
http://www.lenovo.com/support.
Note: For this procedure, it helps to lay the computer on its side.
page 9.
shown.
Chapter 3. Installing options and replacing hardware
37