Table of Contents
Advertisement
3. Disconnect the signal cable and the power cable from the hard disk drive.
4. Pull the handle to release and remove the hard disk drive from the hard-disk-drive cage.
Figure 110. Removing the secondary hard disk drive
5. Flex the sides of the bracket to remove the hard disk drive from the bracket.
6. To install a new hard disk drive into the bracket, flex the bracket and align pin
pin
4
on the bracket with the corresponding holes in the hard disk drive. Do not touch the circuit
board
5
on the bottom of the hard disk drive.
Figure 111. Installing the hard disk drive into the bracket
7. Slide the new hard disk drive into the drive cage until it snaps into position.
150
P320 Hardware Maintenance Manual
1
, pin
2
, pin
3
, and
Advertisement
Table of Contents
