Table of Contents
Advertisement
Figure 112. Installing the secondary hard disk drive
8. Connect the signal cable and the power cable to the new hard disk drive.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 166.
Solid-state drive
The solid-state drive is only available on some models.
Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
Installing the solid-state drive
To install the solid-state drive, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 91.
2. Install the solid-state drive into the storage converter shipped with the solid-state drive. Then install the
four screws to secure the solid-state drive to the storage converter.
.
Chapter 9
Hardware installation and replacement
151
Advertisement
Table of Contents
