Table of Contents
Advertisement
To install or replace a hard disk drive in the front-access storage enclosure, do the following:
1. Before replacing an old hard disk drive, safely eject the old hard disk drive from the operating system
first. For more information, see the Windows help system.
2. Unlock the enclosure cover with the provided key as shown. Press the notch
cover.
Figure 60. Opening the front-access storage enclosure cover
3. Press the pit on the bracket cover, and then grasp the tilted cover to pull the bracket out of the
front-access storage enclosure.
Figure 61. Removing the hard disk drive from the front-access storage enclosure
4. Flex both sides of the bracket to remove the hard disk drive from the bracket.
Figure 62. Removing the hard disk drive from the bracket
5. Flex both sides of the bracket and align pins
hard disk drive. Do not touch the circuit board on the hard disk drive.
Note: Ensure that the circuit board faces downward and the connectors face toward the rear of the
bracket.
120
P320 Hardware Maintenance Manual
1
on the bracket with the corresponding holes in the new
a
to open the enclosure
Advertisement
Table of Contents
