Getting Started - QOLSYS IQ Panel User Manual

GETTING STARTED

Let's start by connecting your power.
Plug in the power connector
Now let's put on your cover and attach the table stand.
Place the top of the cover onto
the panel' s back plate
Plug in your panel, power it on
Plug in the power supply
provided with your panel
(note: if your panel has been professionally installed, skip this page)
Route the wire behind the
retainer clip
Push the cover down until it
snaps in place
Push and hold the standby
button on the side of the panel
for 3 seconds
Insert the wire into the strain-
relief
Insert the table stand into the
mounting holes and push upward
until it snaps into place
Once the panel powers up, the
home screen will appear.