Ethernet Ports; Network Settings Menu - GE Multilin 850 Communications Manual

ETHERNET PORTS

Ethernet Ports

Network Settings Menu

NOTE:
NOTE:
2-6
The following communication offerings are available.
Base Offering
Modes: 10/100 Mbps
One Port: RJ45
Protocol: Modbus TCP
Communications Card Option "C" - 2x Copper (RJ45) Ports
Modes: 10/100 MB
Two Ports: RJ45 (with this option both enabled ports are on the communications card; the
Ethernet port located on the base CPU is disabled)
Protocols: Modbus TCP, DNP 3.0, IEC 60870-5-104, IEC 61850 GOOSE, IEEE 1588, SNTP, IEC
62439-3 clause 4 (PRP)
Communications Card Option "S" - 2x ST Fiber Ports
Modes: 100 MB
Two Ports: ST (with this option both enabled ports are on the communications card; the
Ethernet port located on the base CPU is disabled)
Protocols: Modbus TCP, DNP 3.0, IEC 60870-5-104, IEC 61850 GOOSE, IEEE 1588, SNTP, IEC
62439-3 clause 4 (PRP)
Wavelength: 1310 nm
Typical link distance: 4 km
The following are the network settings menu of the 8 Series relay to accommodate the
features of the 8 Series relay product. If the communications card is installed network port
1 is no longer available. When using more than one Ethernet port, configure each to
belong to a different network or subnet using the IP addresses and mask, else
communication becomes unpredictable when more than one port is configured to the
same subnet.
The softkeys and Down/Up key can be used to enter an IP address. When entering an IP
address you must press the "Back" key first to switch between softkey mode and the
Down/Up key mode.
NETWORK 1, 4, 5, PRT1(4,5) IP ADDRESS
Range: Standard IPV4 Address format
Default: 169.254.3.3 (Port 1)
Default: 127.0.0.1 (Port 4, 5)
The setting sets the port's IPV4 address in standard IPV4 format.
The setting is valid on port 1 if the optional communications card is not present.
The setting is valid on port 5 if port 4's OPERATION is set to INDEPENDENT.
PRT1(4,5) SUBNET IP MASK
Range: Standard IPV4 mask format
Default: 255.255.255.0 (Port 1)
Default: 0.0.0.0 (Port 4, 5)
This setting specifies the IPv4 mask associated with the corresponding port IP address.
CHAPTER 2: COMMUNICATION PORTS
8 SERIES PROTECTIVE RELAY PLATFORM – COMMUNICATIONS GUIDE