FOLDING POWER RACK PARTS LIST To begin, match up all the parts with the following parts diagrams: BOX 1 BOX 2 (8) Hex Nut M16 (8) Hex Bolt M16x110 (8) Spring Washer (8) Flat Washer DIAGRAM NO. PACKAGE NO. PART NUMBER DESCRIPTION P400181-1 Upright Post...
Page 3
PLEASE NOTE Two 2” x 10” stringers must be mounted into a minimum of four studs. The vertical center of the top stringer should be mounted 76” from level ground. The vertical center of the bottom stringer should be mounted 7.25” from level ground. NECESSARY HARDWARE MAY VARY ACCORDING TO YOUR MOUNTING SURFACE.
Page 4
BUILD ON A FLAT AND LEVEL SURFACE. STEP 1 Attach LONG SIDE BRACING + SHORT HINGE (3) to one UPRIGHT POLE (1) using four HEX BOLTS M16x110 (6), four FLAT WASHERS (7), four SPRING WASHERS (8), and four HEX NUTS (9). Attach SHORT SIDE BRACING + LONG HINGE (4) to the other ...
Page 5
STEP 2 Attach PULLUP BAR (14) to the top of the UPRIGHT POLES (1) using two PULL UP BAR PINS (13) and two PIN LOCKS (10).
Page 6
STEP 3 Mount the SIDE BRACINGS + HINGES (3 & 4) to your wall using the pictured measurements. NOTE: The 2 pcs of (3) should be on the same side aligned vertically and the 2 pcs of (4) should be on the other side aligned vertically.
TROUBLESHOOTING PROBLEM PROBABLE CAUSE SOLUTION Rack slides right, but not Top mount is slightly to the Move top mount slightly left. left of the bottom mount. to the right. Rack slides left, but not Top mount is slightly to the Move top mount slightly right.
Keep others and pets away from equipment when in use. Always make sure all bolts and nuts are securely tightened prior to each use. Follow all safety instructions in this manual. TITAN FITNESS 141 Eastley St. Ste. 113 Collierville, TN 38017 (800) 605-8241 www.titan.fitness...
Need help?
Do you have a question about the 4FPWR and is the answer not in the manual?
Questions and answers