Connections To Be Made - Axxess ASWC-1 Installation Manual

Connections to be made

B. For Metra OE radios: Connect the steering wheel control
Key 1 wire (Gray) to the Brown wire of the ASWC-1. Isolate and
tape the Brown/White wire, it will not be used.
C. For Kenwood, or select JVC's with a Blue/Yellow steering
wheel control wire: Connect the Kenwood/JVC steering wheel
control wire to the Brown wire of the ASWC-1. Isolate and tape
the Brown/White wire, it will not be used.
Note: Some of the newer Kenwood radios will auto detect as a
JVC. If this is the case, manually set the radio type, refer to the
Changing Radio Type section (pp. 12-13).
D. For XITE radios: Connect the steering wheel control SWC-2 wire
from the radio to the Brown wire of the ASWC-1. Isolate and tape
the Brown/White wire, it will not be used.
2) For Parrot Asteroid Smart or Tablets: Connect the 3.5mm jack of
the ASWC-1 into the female 3.5mm jack of the AX-SWC-PARROT
(sold separately). Then plug the 4-pin male harness into the
corresponding steering wheel control female harness in the radio.
Note: AX-SWC-PARROT is required (sold separately) and the radio
must be updated to rev. 2.1.4 or higher. Additionally, the ASWC-1
must be updated to the most recent software available.
3) For all other radios: Plug in the male 3.5mm connector of the
ASWC-1 into the back of the aftermarket radio, designated for
an external steering wheel control interface. Please refer to the
aftermarket radios manual if in doubt where the 3.5mm connector
of the ASWC-1 goes into.
ASWC-1 Installation
7