Download Print this page

Connections To Be Made - Axxess XSVI-9004-NAV Installation Instructions

Audi can interface 2002-2013

Advertisement

From the LD-AX-XSVI-AU1 harness to the aftermarket radio
(a) From the 12-pin harness:
• Connect the Red wire to the accessory wire.
• Connect the Orange wire to the illumination wire, if the aftermarket radio has
no illumination wire, tape off the Orange wire.
• Connect the Blue/White wire to the amp turn on wire (this wire must be
connected to hear sound from the factory amplifier).
Note: There is a Blue wire on the 40-pin harness to connect as well.
The following wires are for aftermarket multimedia/navigation radios that provide
these wires (if not required, tape them off and disregard them):
• Connect the Light Green wire to the parking brake wire (if applicable).
• Connect the Green/Purple wire to the reverse wire (if applicable).
• The Blue/Pink wire will not be used, tape it off and disregard it.
Note: This wire will be on the 40-pin harness instead.
(b) From the 40-pin harness:
• Connect the Black and Black/White wires to the ground wire.
• Connect the Yellow wire to the battery wire.
XSVI-9004-NAV

Connections to be made

• Connect the Blue wire to the amp turn on wire (this wire must be connected
to hear sound from the factory amplifier).
The following wire is for an aftermarket multimedia/navigation radio that
provides this wire, if not required, tape it off and disregard it:
• Connect the Blue/Pink wire to the speed sense wire (V.S.S.), if applicable.
For non-BOSE systems:
• Disregard the White RCA, it will not be used in this application.
• Disregard the Gray RCA, it will not be used in this application.
• Connect the Green RCA to the left rear RCA output.
• Connect the Purple RCA to the right rear RCA output.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
Tape off and disregard the following wires, they will not be used in
this application:
• The Green, Green/Black, Purple, Purple/Black wires.

Advertisement

loading

This manual is also suitable for:

Ld-ax-xsvi-au1Ld-ax-xsvi-au2