Manual Programming Mode - Axxess ASWC-1 Installation Manual

Manual Programming Mode

If your vehicle is not listed for auto detection by the ASWC-1 on
the Axxess website, www.axxessinterfaces.com, you may be able to
manually program a non-data communication vehicle using the
following steps.
Tip: If you do not know if you have a data communication
vehicle or not, refer to the "ASWC-1 Vehicle Instruction" document,
from www.axxessinterfaces.com. If it indicates to press and release
the Volume Up button repeatedly to program the ASWC-1, then you
have a data communication vehicle.
Note: Not every radio will have all the possible steering wheel
control commands on the steering wheel. Aftermarket radios that
do not have Bluetooth will not recognize the PTT (Push to Talk) or
On/Off Hook commands, however these buttons may be able to be
manually programmed to do other commands. Please refer to the
radio owner's manual or radio vendor for specific commands that
the radio will recognize.
Note: Please read all Manual Programming Steps before beginning.
1) Follow the steps in the Connections to be Made section (p. 6-7)to
wire up the ASWC-1 to your radio.
2) Turn the ignition on, then press and hold the Reset button on the
ASWC-1 for approximately 10 seconds until the LED on the ASWC-1
flashes slow; and then release the Reset button.
3) At this point, press and hold the Volume Up button on the steering
wheel for 7 seconds until the LED goes solid. Now release the
Volume Up button, and the LED will go off. Volume Up has now
been programmed.
ASWC-1 Troubleshooting
19