Control Process Error - Mitsubishi Electric MELSERVO-J4 Instruction Manual Trouble Shooting

1. TROUBLESHOOTING
Alarm No.: 14 Name: Control process error
Alarm content
Detail
Detail name
No.
14.2 Control process (1) The MR-J3-T10 came
error 2
(2)
(3)
(4)
(5) Something near the
(6) The servo amplifier is
Alarm No.: 14 Name: Control process error
Alarm content
Detail
Detail name
No.
14.3 Control process Check it with the check method for [AL. 14.1].
error 3
14.4 Control process
error 4
14.5 Control process
error 5
14.6 Control process
error 6
14.7 Control process
error 7
14.8 Control process
error 8
14.9 Control process
error 9
14.A Control process
error 10
[RJ010]: MR-J3-T10 came off.
The process did not complete within the specified time.
Cause
Check if [AL. 74
off during the CC-Link Option card error 1]
IE communication. occurred with alarm
history.
A synchronous signal Replace the controller,
error transmitted from and then check the
the controller occurred. repeatability.
Adaptive tuning mode Check the setting of
([Pr. PB01]) or vibration [Pr. PB01] or [Pr.
suppression control PB02].
tuning mode ([Pr.
PB02]) has been
executed for multiple
axes simultaneously.
The parameter setting is Check if the parameter
incorrect. setting is incorrect.
Check the power
device caused it. supply for noise.
Check if the connector
is shorted.
Replace the servo
malfunctioning. amplifier, and then
check the
repeatability.
The process did not complete within the specified time.
Cause
Check method Check result
It occurred.
It did not occur.
It is repeatable.
It is not repeatable.
It has been executed
for multiple axes
simultaneously.
It has not been
executed for multiple
axes simultaneously.
It is incorrect.
It is correct.
It has a failure.
It has no failure.
It is not repeatable.
Check method Check result
1 - 10
Action Target
Check it with the [RJ010]
check method for [AL.
74].
Check (2).
Replace the servo [B]
amplifier. [WB]
Check (3).
Execute it for each [WB]
axis.
Check (4).
Set it correctly. [A]
[B]
Check (5).
[WB]
Take
[RJ010]
countermeasures
against its cause.
Check (6).
Replace the servo
amplifier.
Action Target