Table of Contents
Advertisement
Setting the Bad Zone Recovery Reset Hold Time
(root/config/zone/bzht)
The Bad Zone Recovery Hold Time is the amount of time that the switch keeps the ports
in bypass mode before attempting to re-insert the ports into the zone. This setting is
measured in milliseconds (.001 seconds). The default Reset Hold Time setting is 100.
To change the time interval:
1. From the Zoning configuration menu (root/config/zone), type bzht and press E
2. Type the new time interval and press E
Setting the Bad Zone Recovery Delay Time (root/config/zone/bzdt)
The Bad Zone Recovery Delay Time is the amount of time that the switch waits after a
zone goes down before attempting to recover the zone. This setting is measured in
seconds. The default Delay Time setting is 5.
To change the time interval:
1. From the Zoning configuration menu (root/config/zone), type bzdt and press E
2. Type the new time interval and press E
Adding a port member to a zone (root/config/zone/addprt)
This command adds a port to a zone. Each port may be added to zones 1-11. Zone 0 is
the default zone and is not user definable. Zone 0 contains all ports not included in
zones 1-11.
When displaying the zone information and zoning is not active, Zone 0 displays all ports.
If zoning is active, Zone 0 only shows the ports currently active in Zone 0.
Note: Changes to zone configurations require that zoning be active. See "Activating
To add a port to a zone:
From the Zoning configuration menu (root/config/zone), type addprt <zone number>
<port numbers> and press E
Note: To add multiple port members, use spaces or commas between port members.
For example: If Zone 1 will consist of an HBA (port 3) and two targets (ports 5 and 7)
then to create Zone 1, type addprt 1 3,5,7 and press E
42
2006 Model L10 Storage Switch
The current time interval appears in brackets before the command prompt.
milliseconds (mSec).
The current time interval appears in brackets before the command prompt.
zoning (root/config/zone/act)" on page 43.
. The valid range is 10 to 1000
NTER
. The valid range is 1 to 32 seconds.
NTER
.
NTER
.
NTER
.
NTER
.
NTER
Advertisement
Table of Contents
