Saving Configuration Changes - IBM TotalStorage L10 Cli Reference Manual

Storage switch 2006

Hide thumbs Also See for TotalStorage L10:

Quick reference (2 pages)

Table Of Contents

Table of Contents

Note: Up to 10 concurrent telnet sessions may access the switch.

Once logged in to the CLI, the Root menu (main menu) is displayed. The CLI

incorporates a menu-based interface featuring a list of menus and commands. Each

menu offers a selection of commands in a numbered list. Commands are entered at the

command prompt. The command prompt also indicates the current menu level (for

example, root/config>).

To enter a CLI command:

• Type the actual command text. For example, to select the Configuration menu from the

Root menu, type config and press E

–or–

• Type the number of the command. Using the previous example, to select the

Configuration menu from the Root menu, type 1 and press E

–or–

• Type the first few letters of the command. Either two or more letters are required to

make the command unique. Using the original example, to select the Configuration

menu from the Root menu, type co and press E

From the Root menu, you can also navigate to a specific command in a sub-menu by

entering the first few letters of the sub menu, a space, and then the first few letters of

the command. For example, to view system information under the Show sub-menu:

Type sh sys and press E

To return to the previous menu, type .. and press E

To return directly to the Root menu, type root and press E

To navigate from one menu to another menu, type in the complete menu command and

press E

For example, type root show sysinfo at the command prompt while in the Firmware

menu, press E

To cancel a prompt or input request, press E

If an incorrect command is entered, the 'ERROR: Invalid Command' message appears.

If this message appears, ensure the correct command syntax is being entered and try

again.

To display help for specific command, type ? <command name or number> and press

NTER