Table of Contents
Advertisement
Basic operations
Power on / off
Press the [
] key to turn the unit on. The
buttons on the front of the unit light up and
the current mode status appears on the LCD.
Press the [
] key to power off the unit.
Audible beep confirmation
An audible beep tone confirms each function
selection. The Beep tone can be disabled
through the Setup menu.
Mute
Press momentarily to activate the MUTE
function. Press again to resume normal
listening. If the MUTE wire is connected,
audio output mutes when a phone call is
received by the mobile phone.
Open SOURCE MENU
Press the [SRC] key on the front panel or
remote control or touch the top left corner of
the screen to open the SOURCE MENU.
Do the above operation again to return to the
original source.
Playing source selection
You can use the touch screen to change
the source through the SOURCE MENU. To
access the SOURCE MENU, touch the top
left corner of the screen or press the [SRC]
key. Touch the DISC, RADIO, USB, SD,
CAMERA, BLUETOOTH (BT), AUXIN or
SWC to select the corresponding source.
Note:
If an iPod® is attached to the USB port, "iPod"
appears instead of the text "USB."
Volume adjustment
Volume Increase/Decrease
To increase or decrease the volume level,
turn the rotary encoder on the front panel.
When the volume level reaches "0" or "40", a
beep sounds, indicating that the adjustment
limit has been reached. The TFT screen
displays the volume level for 3 seconds.
Programmable turn-on volume
This feature allows the user to select a turn-
on volume setting regardless of the volume
setting prior to turning the unit off. To program
a specific turn-on volume level, turn the rotary
encoder to adjust the volume to the desired
turn-on volume. Push and hold the rotary
encoder while the blue speaker icon and level
indication is displayed on the screen. The
unit will beep to confirm your turn-on volume
setting.
Audio control menu
The Audio Control feature allows you to
easily adjust your audio system to meet the
acoustical characteristics of your vehicle,
which vary depending on the type of vehicle
and its measurements. Proper setting of the
Fader and Balance boosts the effects of the
cabin equalizer.
System reset
To correct a system halt or other illegal
operation, use the tip of a pen to press the
[RESET] key located on the panel. After a
system reset, the unit restores all factory
default settings.
Note:
If the unit is reset while a DVD is playing,
the DVD resumes play once the reset is
complete.
Change aspect ratio
Press the [WIDE] key on the remote control
to adjust the aspect ratio.
Image settings
1. Enter image setting mode
Press the [PIC] key on the remote control.
2. Select one item to adjust
Rotate to adjust volume knob or press the
[
]/[
] keys on the remote control.
3. Adjust the value
Rotate to adjust volume knob or press the
[
]/[
] keys on the remote control.
4. Exit image setting mode
To exit image setting mode, repeat the first
step or stop operation for some seconds.
EN - 4
Advertisement
Table of Contents
