Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Caliber Manuals
  4. Car Stereo System
  5. RMD 210
  6. Instruction manual

Caliber RMD 210 Instruction Manual

Hide thumbs

Advertisement

Quick Links

Download this manual

Advertisement

loading

Related Manuals for Caliber RMD 210

Summary of Contents for Caliber RMD 210

  • Page 2: Location And Function Of Controls

    LOCATION AND FUNCTION OF CONTROLS MODE PUSH BAND AS/PS 2/INT 3/RPT 4/RDM 5/-10 6/+10 MUTE 1. RELEASE BUTTON Press the REL button to release the front control panel from the unit chassis, then pull it up a little to remove from the unit chassis. When the front control panel is removed the LED indicator flashes.
  • Page 3 1) TA SEEK/TA ALARM: TA SEEK mode: when newly tuned station does not receive TP information for 5 seconds, the radio retunes to next station which has a different PI to the last station, but has the TP information. When TP information gets lost at the current station for retune time which is set by RETUNE SHORT(90 seconds) or RETUNE LONG(150 seconds), the radio starts to retune to next same PI station.
  • Page 4 4.MUTE BUTTON When the unit is powered on, press this button to switch the MUTE on/off. 5. LCD Display 6&7. TUNE, SEEK, TRACK, SKIP UP / DOWN BUTTONS a) In RADIO mode: Press the >>| or |<< button briefly to manually tune up/down for your desired radio station step by step.
  • Page 5 * TA interruption function: The current traffic announcement is cancelled by pressing this key. But the TA mode will not be off. * When TA is on, SEEK, (SCAN), AUTO MEMORY function can be received or saved only when traffic program identification code has been received. When TA is ON, traffic program identification code is not received during specified time.
  • Page 6 14-19. PRESET STATION MEMORY AND TOP/>||, INT, RPT, RDM BUTTONS a) During radio mode: When pressed briefly, these buttons select a preset station directly. If the six buttons are pressed for more than 2 seconds, the station currently being listened to is memorized into the selected preset button.
  • Page 7 INSTALLATION METHOD This is an anti-theft installation method. The main unit has a METAL MOUNTING SLEEVE. Please connect the wiring, eg, the Power Supply, the Speakers and the Antenna according to the requirements of this Instruction Manual, then install the metal mounting sleeve into the car as per the diagram illustrated below.

  • Page 8: Troubleshooting

    TROUBLE SHOOTING Before using the check list please make all the connections first. If you still have questions after going through the checklist, please consult your local customer service representative. Common Symptoms Cause Solution If the power supply is properly connected to The car ignition is switched off.

  • Page 9: Wires Connection

    WIRES CONNECTION RCA LINE OUT RCA LINE OUT REAR RIGHT FRONT RIGHT RCA LINE OUT RCA LINE OUT WHITE WHITE REAR LEFT FRONT LEFT ISO SOCKET ANTENNA JACK ISO SOCKET SKETCH CONNECTOR A CONNECTOR B 1. Rear Right Speaker (+) 2.

  • Page 10: Specification

    SPECIFICATION GENERAL Supply Voltage DC 12V. Negative Ground Current Consumption Max.10A Power Output 25Watts X 4(measured at DC 14.4V) Number of channels 2 STEREO channels. Unit Dimensions 178[W] X 101.5[D] X 50[H] mm. FM SECTION Frequency range 87.5MHz -108MHz Effective sensitivity 3uV.