Table of Contents
Advertisement
OPERATING INSTRUCTIONS
1.
POWER ON/OFF (
By pressing this key, the unit is on or off.
This unit is turned on by pressing any key.
2. FUNCTION SELECT BUTTON: BASS/TREBLE/BALANCE/FADER /
INITIAL VOLUME / CT / TA VOL / EON / DSP
3.
VOLUME UP/DOWN
Turning VOL knob (right/left) to adjust VOL/BAS/TRE/BAL/FAD. To select other functions, press the VOL knob shortly
until the desired functions are shown on the display. Figure 1 shows how to control functions that are selected using
the VOL knob.
Increase or decrease the volume by turning VOL knob (right/left). These buttons can be used to adjust the BASS,
TREBLE, BALANCE and FADER.
2 sec.
SEL
IN VOL
Press and hold VOL knob to adjust INIT VOL /CT/TA VOL/EON ON/DSP
IN VOL: Can adjust Initial Volume level using this mode.
ADJ:
Can adjust clock time. Turn VOL knob clockwise to set hours and counter clockwise to set minutes.
TA VOL: Can adjust TA Volume (The volume level when Traffic announcement is transmitted).
EON:
Can selected EON condition, ON or OFF.
DSP:
Can select DSP mode (Classic, Rock, POP, Flat)
4.
PRESET STATIONS (1,2,3,4,5,6)
When pressed momentarily, these keys select a preset station directly. When pressed longer than 1 sec., current
station is stored in preset memory bank.
USING THE RDS FUNCTION
What is RDS?
The RDS (Radio Data System) is a digital information system developed by the EBU (European Broadcast Union).
Piggy-backed on normal FM broadcasts, RDS offers a variety of information services and automatic retuning functions
for RDS-compatible car stereos.
In 1988, RDS became available in the United Kingdom, France, West Germany, Ireland and Sweden. Test transmis-
sions are being conducted in many other European countries. It is expected that RDS will be available in most western
European countries in the near future.
5.
'AF/REG' function (ALTERNATIVE FREQUENCIES)
When pressed momentarily, AF/REG switching mode is selected.
When AF/REG switching mode is selected, the radio checks the signal strength of the AF all the time. When pressed
long, it is activated as regional mode ON/OFF.
– Regional mode ON:
AF switching or PI SEEK is implemented to the station which have all PI codes same as current station. REG seg-
ment is turned on, in LCD display.
– Regional mode OFF
The regional code in the format of PI code is ignored when AF switching or PI SEEK is implemented.
6.
'TA' function (TRAFFIC ANNOUNCEMENT)
When pressed momentarily, it is activated as TA mode on or off
When TA mode is on and traffic announcement is transmitted
– If the volume level was under the threshold point, it will be raised to the threshold point.
– When TP station is received, TP segment is turned on in LCD display.
7.
'PTY' function (PROGRAM TYPE)
When pressed momentarily, it is activated as TPY ON/OFF function and start to search corresponding PTY informa-
tion then stops if the corresponding PTY information is detected.
By pressing this key longer than sec., you can select PTY mode by turning Volume knob as below.
NEWS--AFFAIRS--INFO--SPORT--EDUCATE--DRAMA--CULTURE--SCIENCE--VARIED--POP--ROCK--EASY M--
LIGHT M--CLASSIC--OTHER M--WEATHER--FINANCE--CHILDREN--SOCIAL--RELIGION--PHONE IN--TRAVEL-
-LEISURE--JAZZ--COUNTRY--NATION. M--OLDIES--FOLK M--DOCUMENT--TEST--ALARM.
)
1
2
3
2
Fig. 1 Selection of sound control functions
1. VOL . SEL 3. BASS 4. TRE 5. BAL 6. FAD
SEL
ADJ
SEL
4
2
5
2
TA VOL
SEL
EON
EN-5
6
2
SEL
DSP
Advertisement
Table of Contents
