Procedures For External Modules - Tektronix AWG5000 Series Service Manual

Removal and Installation Procedures

Procedures for External Modules

Handle Unit
Snaps
Cosmetic Cover (Top)
Cosmetic Cover (Bottom)
4-10
You need a screwdriver with a T-20 Torx tip (items 1 and 4).
Removal. To remove the handle unit, refer to Figure 4-3 and follow these steps:
1. Remove the two screws securing the handle base bracket to the cosmetic cover.
2. Grasp the bracket and handle away from the cosmetic cover.
Installation. To install, reverse this procedure.
You need a screwdriver with a T-15 Torx tip (items 1 and 2).
Removal. To remove the snaps, refer to Figure 4-3 and follow these steps:
1. Remove the four screws securing the snaps to the cosmetic cover.
2. Lift the snaps away from the cosmetic cover.
Installation. To install, reverse this procedure.
You need a screwdriver with a T-15 Torx tip (items 1 and 2).
Removal. To remove the top cosmetic cover, refer to Figure 4-3 and follow these
steps:
1. Remove the snaps.
2. Remove the two screws securing the cosmetic cover to the chassis.
3. Loosen the cover with a detaching tool, such as a flat-blade screwdriver.
4. Tilt the rear side of the cover up, and then pull it off the chassis.
Installation. To install, reverse this procedure.
You need a screwdriver with a T-15 Torx tip (items 1 and 2).
Removal. To remove the top cosmetic cover, refer to Figure 4-3 and follow these
steps:
1. Remove the handle unit.
2. Orient the instrument so its top is down on the work surface and its rear is
facing you.
3. Remove the two screws securing the cosmetic cover to the chassis.
4. Loosen the cover with a detaching tool, such as a flat-blade screwdriver.
AWG5000 Series Service Manual