Phoneutility - Intermec 700 Series User Manual

700 Series Color Mobile Computer User's Manual

PhoneUtility

Note: This application is for GPRS radios only, due to E911 requirements
issued by the FCC. CDMA radios no longer have voice activation.
With the WAN radio module installed in your 700 Series Computer, you
can send and receive telephone calls. Use the speaker on the back of the
computer as your earpiece and use the connector on the bottom of the
computer for your mouthpiece.
Tap Start > PhoneUtility from the Today screen to access the application
which will process your phone calls. Tap Exit or ok to close this
application and return to the Today screen.
Audio Mode
Select either Handset or Speakerphone from the Audio Mode box, then
do the following to send or answer a phone call:
S Tap the numbers for a phone call, using Clear to erase each digit, then
tap Send to initiate the call.
S Tap Answer to receive an incoming call.
S Tap End to disconnect a transaction.
S Drag the Vol slider up or down to adjust the speaker volume.
S Drag the Mic slider up or down to adjust the microphone sensitivity.
Handset Audio
Mode
Chapter 4 — Network Support
Speakerphone Audio
Mode
165