Using The Sampler For The First Time; Getting The Sampler Into "Standby State - Hach Sigma 900 User Manual

5.4 Using the Sampler for the First Time

5.4.1 Getting the Sampler into "Standby State"

5.4.1.1 Accessing Parameter Entry Mode
8837prg.fm
When turning the sampler on for the first time press the * key to enter
parameter entry mode and continue with Step 3 in
To access Parameter Entry mode, the sampler must be in a standby state.
That is, a program cannot be in progress or "running". The sampler is in a
standby state when the display indicates any one of the following:
,
START PROGRAM COMPLETE
, press the
PROGRAM RUNNING
place the sampler in the "Program Halted" standby state.
If the display reads
RE-ENTER PROGRAM, DEPRESS*
for further instructions.
1. With sampler in a standby state, press the
Parameter Entry mode. The display will read:
2. Press the key to change the parameters.
YES
3. The display will read:
ADVANCED PROGRAM?
program and causes the advanced program prompts to appear in the
programming steps. Refer to
Note: Press the key to review the existing parameter entries. This disables the
NO
advanced program and removes the advanced program prompts from the
programming steps.
4. Press the key to accept the advanced program. The display will read
YES
ENTER NUMBER OF SAMPLE BOTTLES, TOTAL BOTTLES = --
5. Use the numerical keys to enter the number of sample bottles located in
the bottle tray. You may enter 1 or 24 in the standard program, or 1, 2, 4,
8, or 24 in the advanced program.
6. Press the key to accept the number of bottles. The display will read:
YES
ENTER UNITS FOR BOTTLE VOLUME, MILLILITERS?
Note: may be displayed instead of
GALLONS
7. Press to cause other volume units to appear. When the desired units
NO
appear on the display, press the
8. The display will show
whichever was chosen in the previous step.
9. Enter the volume for the individual sample bottle by pressing the
numerical keys.
10. Press the key to accept the volume.
YES
11. The display will read
ENTER UNITS FOR TUBING LENGTH, FEET?
Note: may be displayed instead of
CENTIMETERS
section
, or
PROGRAM HALTED.
key. This will stop the program
CHANGE/HALT
key. This opens the
*
ALTER PARAMETER?
. This enables the advanced
Advanced Program Features on page
.
MILLILITERS
key.
YES
(or
VOLUME = _ _ _ _ _ ml
.
FEET
Using the Sampler for the First Time
Section 5
5.4.1.1.
READY TO
If the display reads
, refer to the next section
.
48.
.
.
),
VOLUME = __ GALLONS
.
Page 37