Operating Your Wireless Controller - Lionel 7-11000 Owner's Manual

Operating your train

Operating your wireless controller

T
urn your wireless controller to the ON position by sliding the button on the right side of the
controller up. An LED on top of the dial will light to indicate the power is on (See Figure 7 on
page 11). See Figure 8 on page 13 for button operations.
Forward
Turn the throttle dial to the right towards GREEN. There are three speeds in the forward
position and the more you turn the dial along the green arrow, the faster the train will run. The
flashing rate of the LED will be consistent with the speed. The 3 speeds are slow (slow blink),
medium (medium blink) and fast (fast blink). Once the locomotive begins to move, the cab light
will turn on and stay on as long as the locomotive is moving.
Stop
Turning the dial to the top will stop the train. Note that it may take up to several seconds for the
train to come to a complete stop depending on how fast it was going. Make sure to bring the train to
a complete stop before changing direction.
Reverse
Turn the dial towards the blue REVERSE position to have the train move in reverse. Again,
there are three speeds in the reverse position. The more you turn the dial along the blue arrow,
the faster the train will go. The flashing rate of the LED will be consistent with the speed.
Bell
Pressing the BELL button activates the locomotive's bell sound.
Center Button with Music Note (Depending on which set purchased)
Pressing the center button marked with a music note activates a special announcement
when stopped and another announcement when moving.
Whistle
Pressing the WHISTLE button activates the locomotive's whistle.
If the locomotive power switch is turned off while the locomotive is moving, it will stop.
Note!
The LED on the controller will begin to blink slowly, signifying it has lost communication
with the locomotive.
If the controller is turned off while the train is running the locomotive will slow down and stop.
The headlight will turn off, cab light will begin flashing and a loud beeping sound will begin
playing (notifying the operator to slide the power switch to the "OFF" position to conserve battery
life).
Leaving the Wireless Controller power ON when not in use will drain the controller's
Note!
battery.
12